| Details: |
1969 Chevrolet Chevelle This is a clean titled solid 69 Chevelle thats set up for an LS1 and T56 with hydraulic clutch. This is for the rolling chassis only. The motor and transmission do not come with the car. using the drivetrain in this car to build a late model LS swap due to time and finances. In order to fit a T56 into Chevelles you need to cut the tunnel out or split it. Due to previous owners poor decision of hacking the tunnel to pieces, it was cut it out and prefabbed a tunnel to fit. It needs to be finished near the shifter box. The only bit of rust is in the trunk which is a few holes. The quarters, doors, floors, roof, and rest are very solid. The front fenders have repaired rust from a previous owner. The body is very straight and could easily be painted with a little work. The entire underside and inside of the floor has been scraped, blasted, POR15d, and undercoated. Its solid as a rock with stock sheet metal. The car comes with the following: All good glass, trim, assorted, pieces. I have 75% of this in the trunk. New functioning manual drum brakes D Disc spindles and booster included 17 Torque Thrusts staggered with NT05R drag radials 12 Bolt Posi 4.10 Speedtech hydraulic clutch bracket and master cylinder installed and done. Speedway body harness (new style) with fuel pump circuits etc. Brand new Brand new Poly body mounts Caprice EFI fuel tank with brand new never used fuel pump assembly Brand new stock type gas tank with new sending unit 67 Low back GTO bucket seats and matching rear seats Newer carpet kit New core support and battery tray Inner fenders are pretty solid except for the passenger side front has some rust Used but good shape OE bumpers and brackets Power steering car with good box Transmission cross member and motor mounts setup for an LS1 T56 combo It has a smoothed firewall. Its welded up and ready to be finished. the motor and trans do not come with the car.
|
